Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Cold Spring Harbor, NY.
Ignitor & Pilot Light Repair
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
Gas Valve Diagnostics
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
Heat Exchanger Inspection & Repair
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
Blower Motor & Limit Switch Repair
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Cold Spring Harbor, NY.
Flue & Venting Repair
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
Thermostat & Control Board Diagnostics
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.
